Product Details:
Voltage: 220-240 Vac, 50Hz
Power consumption: 1 VA
Insulation standard: IP41
Response time: < 0.1 sec

Satronic IRD 1010.1 flame detector:
Introduction:-
The IRD 1010.1 is employed to monitor the flame of an oil burner. This flame monitoring device should be connected to a Satronic oil burner control box. Monitoring is based on
the infra-red flicker principle, in other words, the flickering infra-red light of the flame is detected. The steady radiation from, for example, the glowing refractory layer on the inside
of the boiler, has no effect on the detector. The IRD 1010.1 replaces the IRD 1010, 910, 911 and 911vi. When exchanging the IRD 1010, care must be taken that the corresponding IRD 1010.1 with the same imprint (blue, white or red) is used (see page 3 and 4). When exchanging the IRD 910, 911 or 911vi, care must be taken to wire the sensor correctly (see page 3). For replacement of the IRD 910, 911 or 911vi with IRD 1010.1 is the sensor cable also needed.

Constructional Features:-
The infra-red sensor and the pre-amplifier are hermetically sealed in glass and along with the electronics form an integrated unit in the flame detector. Wiring is by way of a plug connection. The sensitivity control and two LED’s for indication of the flame signal are situated on the rear of the flicker detector.