Product Details:
Voltage: 220-240 Vac, 50Hz or 110-120Vac, 50/60Hz
Power consumption: 1 VA
Insulation standard: IP41
Response time: < 0.1 sec

Satronic IRD 1020 flame detector:
Introduction:-
The IRD 1020.1 detector is used to supervise gas or oil flames. This flame monitoring device should be connected to a Satronic oil burner control box. Monitoring is based on
the infra-red flicker principle, in other words, the flickering infra-red light of the flame is detected. The steady radiation from, for example, the glowing refractory layer on the inside
of the boiler, has no effect on the detector. The IRD 1020.1 replaces the IRD 1020 and 920.
When exchanging the IRD 1020, care must be taken that the corresponding IRD 1020.1 with the same imprint (blue or white) is used (see page 3 and 4). When exchanging the IRD 920, care must be taken to wire the sensor correctly (see page 3), and the existing holder
must be exchanged with the magnetic holder M93. For replacement of the IRD 920 with IRD 1020.1 is the sensor cable also needed.

Constructional Features:-
The infra-red sensor and the pre-amplifier are hermetically sealed in glass and along with the electronics form an integrated unit in the flame detector. Wiring is by way of a
plug connection. The sensitivity control and two LED’s for indication of the flame signal are situated on the rear of the flicker detector.